Wisdom in mind,   enthusiasm at heart.

While audio is life , the Power supply is water , Pure water create the wonderful life ... ...
　

HE-9 (2019 Edition)
Since 1st July 2019
Regenerative Power Supply
Real Balanced ACSS design 
Pure Class A  (9W @ 40 ohm)
Preamp & Headphone amp
3 Type gain modes can drive high and low sensitivity easy

Shipped since July 2019, the unit has upgraded the transformers , can power on long term.

The unit applied input short design but can disable :
         The unit  had design the analog idle input short circuit for avoid the disturb between different sources.
         This design also applied in a lot high end brand devices.
         The working theory :  Without the idle input short circuit ,if the input 5 and input 4 had connect two extra DACs,  while users select the either input 5 and input 4 , the another input signal will fire through the circuits and mix  into the using signal, even though this signal is  weak  but still can degrade on the sound quality.
          With the idle input short circuit function : if user select either the input 5 and input 4, the another input signal will short circuit then no any signal fire through circuits , can keep the sound quality had not degrade.
         Below case users don't want the idle input short circuit function, users can open the chassis, pull off the jumpers of the proper input channels, please note must pull off of left and right channels together :
        1, The same extra source not only connect the unit analog input, but connect with other amps simultaneity.
        2, The same extra source connect to the unit different inputs  at simultaneity.

HP/PRE switch :
          Select the HE- 9 output model  , display "H" mean for headphone output, display " P" mean for preamp output.

Gain switch :  
          The L gain mode has 16DB gain, for drive the headphones which have over 100DB sensitivity or work as preamp.
         The H gain mode has 25DB gain, for drive the headphones which have 80-100DB sensitivity.
         The S gain mode has 31DB gain, for drive the headphones which have 80-100DB sensitivity but with the low output level sources (Available on RCA/ XLR inputs ).
         We have applied the new gain technology ,no any switches, relays or parameter of the amp change while change the gain modes so the sound quality is exact same in different gain modes. Users just want to choice the better mode for easy adjust the volume level.

Selector switch :
          Select the HE-9 inputs from IN 1 to IN 5.

Volume knob :
          Select the HE-9 volume control .

Setting the HE-9 functions:
          While the HE-9 select IN5, and the volume number on "0",turn the volume lower 1 step for active the setting mode. In term the 3 digital number in the display, one digital number blinking , it means this digital number function can be setting. If turn the volume knob lower 1 step, quit the setting mode.
         In setting mode, push the "INPUT" button once, the right one digital number blinking.
         Push the "Gain" button once, the blinking digital number change between 1 and 0 . 1 means the function active, 0 means the function disable.



        The left first digital number means the remote function setting, if it set to 0, whether long or short push the remote controller volume button, the unit volume only change 1 step . If set to 1, push and hold the remote controller volume button, the unit volume change continuously .In case if set to 1 but the unit had control by other devices , set to 0 please.

        The left second digital number is for set the auto dark. Set to 0, the unit display always lights while power on. Set to 1, the unit auto dark after around 10 seconds while the unit power on and without operate any buttons, there is only a LED has light for show the unit power state.

        The right first digital number for set the volume memory function. Set to 0, the unit has not volume memory . Set to 1, the unit has volume memory even restart .