Wisdom in mind,   enthusiasm at heart.

Home Products Warranty Shop Contact Us Shipment Chinese

Precision 3
 (2020 Edition)

Non-Feedback Discrete ACSS Power  Amp
Can work as headphone amp
0W X2 (8 Ohms) & 15W X2 ]40 Ohms Headphone)
Support bridge amp and Bi-amp





Summarize Use Manual Specs Shipping Cost

Please read before power on the Precision 3 (2020 Edition) :
1,      Precision 3 (2020 Edition) had the RCA and ACSS inputs, there is a switch on the center of rear.
         The switch push into for select RCA input, and pull off for select ACSS input.
         Please note you must select the switch while the unit power OFF.
         You can not short the outputs of Precision 3 (2020 Edition), even though it had built in protect but still will lost the warranty.

2,       Precision 3 (2020 Edition) is a pure power amp, you must have a preamp or headphone amp feed to it.
         You CAN'T feed to it from a fixed level output DAC , in case it may damage your speakers or headphones.
         If connect to Audio-gd NFB11, NFB28 , NFB29 or NFB27 ect models, you must ensure the DAC had setting on variable output mode.

3,      Precision 3 (2020 Edition) is a stereo power amp, you can use it drive a pair speakers , or a headphone through adapter cable.

4,      Two units Precision 3 (2020 Edition) can working as bridge mode for boost the output power up to 200W per channel, you may need buy the bridge cable to connect two units.
         You must have a balance output preamp for connect two units Precision 3 (2020 Edition).
         Please note, in bridge mode, the speaker connect as below, the red RCA or ACSS cable connect to right input (your face to Precision 3 (2020 Edition) face, right side input is right input), and the black RCA or ACSS cable connect to left input. The right output connect to speaker as + and left output connect to speaker as -. The output - of Precision 3 (2020 Edition) don't want connect .


5,       Two units Precision 3 (2020 Edition) can working as Bi-amp mode for boost the power up to 140W per channel. You may need buy the bi-amp cable for connect the Precision 3 (2020 Edition). And you must have two pair speakers for connect the speakers working with separate amps.
         You can connect the Precision 3 (2020 Edition) with a balance or unbalance preamp.
         Please note , in Bi-amp mode, your speakers must have the real bi-wires design.
         In our experiences, some speakers even have the 2 groups inputs but they just simply connect as normal 1 groups input.
         We are advice you test your speakers if had the real bi-wires input before purchase the Precision 3 (2020 Edition) .
         Test method: 
         Usually the speakers have the cooper jumpers connect between two groups inputs, take off the jumpers let the one groups without any connect, if the speakers lost some sound, your speakers are the real bi-wires connect.
          You can not connect the bi-amps to a fake bi-wire speakers,  that will damage the amps and lost the warranty.
          In case , you can connect one Precision 3 (2020 Edition) working for one speaker, the Right output connect to bass and left output connect to tweeter .
          In our experience, bi-amp can sound better than some electric frequency divider .

Please click to choice speaker cable if you need :    Cables




               备ק号: 粤ICP备05020367号

@              版权Ҧ: 睿ӭ响

Copyright(C) 2004 www.audio-gd.com All Rights Reserved