| 
		 
				
				
				Detail of the Current Conveyor Technology 
			 
			What's the regenerative power supply : 
				 
             While 
				audio is life , the Power supply is water , Pure water create 
				the wonderful life ,clean power supply reproduce the 
				beautiful sound . 
             The regenerative power supply like a 
				proprietary electric generator built in the unit.  
             It can block most 
				disturb from the power line , supply the ultra clean power supply for 
				the audio amps , reproduce the most neutral and analog sound 
				like audio signal for the system and the users. 
             In the 
				regenerative power supply design, the AC power through the 
				regenerative input transformer 
				, conversion to DC power ,through the class A PSUs power supply 
				for the regenerative wave generator and driver stages .  
             A balance regenerative regular wave 
				generator produce the ultra low distortion 50Hz wave ,through the 
				balance  gain amps and the strong  output stages , 
				drive the regenerative transformers produce the clean AC power 
				supply feed to the separate class A PSUs power supply for the L and R 
				channel preamps . 
            The class A 
				parallel connection PSU has very high input impedance to avoid 
				disturb through the PSU from affecting the signal parts and low 
				output impedance with very fast speed and high linear,  it 
				is a very clean power supply. 
             Audio-gd 
				on the regenerative power supply design points  : 
                    
			1, Through analyzed the AP SYS-2722 ,do a lot practises ,test and 
			listen , full analog design of the regular wave generator have much 
			lower distortion than the digital generator. 
                    
				2, Digital drive stages have higher efficiency , but full analog 
				drive stages have much better analog sound like . 
                    
				3, 400Hz regenerative wave have higher efficiency , 50Hz 
				regenerative wave had much far away the human ears sensitivity 
				area than the 400Hz, boost the sound have much better analog 
				sound like. 
			        
			
			
			  
			ACSS:       
			              The 
			HE-7 is a real fully 
			balanced discrete design. Applies the 8 Pieces Expensive high-end grade PCM1704UK which can support up to 
			24Bit/192KHz  through SPDIF input , 32 Bit / 384KHz through  I2S 
				and USB input . Similar to other PCM1704UK designs , we applied Non-feedback ACSS 
			analog stages. The 
			8 pcs PCM1704UK feed to the ACSS analog
stages without any OPAs and couple caps so it can avoid sound coloration . 
              The ACSS is a non-feedback
technology made with fully discrete amplifiers. Most people know the
global
feedback design can offer better specs in test measurements, and
			classic non-feedback can't do well in test measurements but can offer better
sound for the human's ears. Here is a conflict of the classic circuits.
But the ACSS opens a new field, it can offer a least coloration sound
which is more neutral with very low distortion and high linearity. So
it can retain the dynamics, detail and neutral sound but not sound
bright or harsh. 
			Output buffer:         
    The output buffers are
Non-feedback. For low impedance, we applied the dual FET buffer output stage
which is quite less colored than most conventional circuits. 
			DSP-1 processor: 
			            
			HE-7 has built in DSP 
			processor, which is a Two-channel Digital Interpolation Filter and 
			data in-phase processor for digital audio. This Device offers 
			advanced features for high-performance digital signal processing (DSP) 
			applications up to 450-MHz. Data and Master-clock in-phase 
			processing are without jitters. So HE-7 can offer a clear 
			and focused soundstage, apart from accurate and neutral reproduction 
			of the recorded disc/music. The Stopband Attenuation up to -130DB, 
				enough clean the digital noise , avoid the digital noise degrade 
				on the back stage and make the sound like digital. 
¡@ 
			
				
				
			Filter Characteristics: 
			
			 
			            
			Stopband Attenuation: -130DB. 
			            
			Passband: 0¡ã0.4535Fs. 
			
			
			            
			Passband Ripple: within 
			
			¡Ó0.00001dB. 
             Stopband 
				Attenuation 
				Characteristics¡]-130dB¡^    
             Passband Characteristics¡]-130dB) 
            
			    
			  
             
			
			Power supply: 
			            
			HE-7 applies the excellent 8 pcs PCM1704UK
			and excellent analog 
			output stages, but these are not the only keys of the best sound. 
			The power supply is most important. Even applying the best DA chip 
			and the best amp, if matched to a normal power supply, the total 
			sound may still be average or sound musical, but can't be neutral 
			and detailed. That is why it is easy to find hi-end grade gears 
			maybe without the best chips or amp stages, but with plenteous 
			dedicated DC supply circuits.  
			            The HE-7
			
			
			had
			total 21 PSU
groups are applied.  Uses 
			19 groups of high-quality class A parallel 
			connection PSU with dedicated DC supply double-stage PSU, which can 
			offer very clear DC power for the DAC, producing 
			a very black background and neutral sound characteristic. The 
			double-stage PSU is very important for digital parts. Some designs 
			may have very low jitter in theory, but if the power is supplied by 
			a dirty or low-speed power supply, it will increase the jitter and 
			pollute the data, and degrade the sound quality obviously. 
			             The class A parallel connection PSU has very high input 
			impedance to avoid pulse through the PSU from affecting the DAC and 
			low output impedance with very fast speed and high linearity, so it 
			is a very clean power supply. In my experience, its sound is better 
			than battery power supply, better human sound and neutral. 
			
			
            	Shield:  
				         
				HE-7 has complete separation of digital process, analog left, right
amplifier channels, regenerative drivers and transformer, even the 230V / 120V 
				power input lines had shield in the copper conduit.  
            	         HE-7 uses heavyweight all-aluminum  chassis to prevent the
eddy current of transformers from interfering on circuit board.  
				 
            	Components: 
     
    Uses all audiophile grade
components, including DALE resistors, WIMA caps, custom
order NOVER (UK brand) caps, all audiophile grade input & output
sockets (Neutrik ) and gold IEC socket.  HE-7 all parts of four channels had exact match before install. 
              
			 
		 |